Indicators During Sending/Receiving Operation; Responding To An Attention Indicator Flashes - Utax 261ci User Manual

Troubleshooting > Indicators During Sending/Receiving Operation

Indicators During Sending/Receiving Operation

The Processing and Memory indicators show the fax transmission status.
• The processing indicator blinks during fax transmission and reception.
• The Memory indicator blinks when source data is being stored in memory for memory transmission.
• The Memory indicator is lit when there is source data stored in the memory for delayed transmission.
•

Responding to an Attention Indicator Flashes

If an attention indicator flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated on
the touch panel when [Status/Job Cancel] is pressed or the attention indicator flashes for 1.5 seconds, check the
following.
Symptom
Cannot send fax.
Checkpoints
Is the modular cord connected
correctly?
Is Permitted FAX No. or
Permitted ID No. registered
correctly?
Has a communication error
occurred?
Is the destination FAX line busy?
Does the destination FAX
machine respond?
Is there an error other than
above?
10-2
Corrective Actions
Connect the modular cord correctly.
Check Permitted FAX No. and Permitted
ID No.
Check error codes in the TX/RX Result
Report and Activity Report. If the error
code starts with "U" or "E", perform the
corresponding procedure.
Send again.
Send again.
Contact your Service Representative.
Reference
Page
—
9-10
10-5
—
—
—