Furuno DRS4W Operator's Manual page 20

Installation with the radome mount
The optional radome mount lets you fasten
the radar sensor to a mast on a sailboat.
Name, Type: Radome Mount, OP03-209
Code No.: 001-078-350
Name Type
Mounting 03-018-
plate 9001-0
Support 03-018-
plate (1) 9005-0
Support 03-018-
plate (2) 9006-0
Bracket 03-028-
(1) 9101-1
Bracket 03-028-
(2) 9101-2
Fixing 03-028-
plate 9103-1
Hex bolt M8×20
w/washer SUS304
Hex bolt M4×12
w/washer SUS304
How to assemble the bracket
1. Fasten the fixing plates to brackets (1)
and (2) with four M8×20 hex bolts.
2. Fit brackets (1) and (2) loosely with sup-
port plates (1) and (2) using four M4×12
hex bolts, so that the gap between the
brackets can be adjusted.
3. Place the mounting plate on the bracket
and fix it loosely with four M8×20 hex
bolts.
Code No. Qty
100-206- 1
740-10
100-206- 1
780-10
100-206- 1
790-10
100-206- 1
811-10
100-206- 1
812-10
100-206- 2
831-10
000-162- 8
955-10
000-162- 4
956-10
How to fasten the bracket to the mast
1. Drill eight holes of 6.5 mm diameter in the
mast and fix the bracket with eight stain-
less steel rivets (local supply) of 6.4 mm
diameter.
2. Tighten the bolts on the bracket.
3. Fasten the radar sensor to the bracket.
Connect the power cable to the power source,
observing the guidelines for laying the power
cable shown on this page.
M8×20
Fixing
plate
M8×20
Bracket (2)
How to assemble the radome mount
Rivet
How to fasten the sensor to the radome mount
14
3. INSTALLATION
ASSEMBLED
RADOME MOUNT
M8×20
Mounting plate
Bracket (1)
Support
plate (2)
Support
plate (1)
M4×12
M10×25