Table of Contents
Advertisement
9. When the inner chassis is fully seated into the outer enclosure, tighten the thumbscrews
on the rear panel, circled below in red. Press each screw in toward the enclosure, then twist
clockwise while still applying pressure. Keep twisting until you feel increased resistance.
Assembly is now complete. Proceed to Section 2.2 for information on connecting the
Helios to a computer and to other Thunderbolt devices.
OWC DIGITAL - MERCURY HELIOS
7
DEVICE SETUP
Advertisement
Table of Contents
Need help?
Do you have a question about the Mercury Helios and is the answer not in the manual?