Lighting Instructions; To Turn Off Gas To Appliance - Montigo H38DF-ST Indoor Installation, Operation & Maintenance Manual

H38DF-ST
For Your Safety - READ BEFORE LIGHTING:
WARNING:
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
Q
Do not touch any electrical switch; do not use any phone
Q
in your building.
Immediately call your gas supplier from a neighbour's
Q
phone. Follow the gas supplier's instructions.
1. STOP! Read the safety information above on this label.
2. Lift out the lower Horizontal access panel.
3. Push in gas control knob and turn clockwise
4. Wait five (5) minutes to clear out any gas. Smell for gas,
including near the floor. If you then smell gas, STOP! Follow
"B" in the safety information above on this label. If you don't
smell gas, go to the next step.
5. Locate pilot burner (See illustration at right.) and follow steps
below.
6. Turn knob on gas control counter clockwise
"PILOT."
1. Turn off remote switch.
2. Lift out the lower Horizontal access panel.
Part No. XG0207 -092109
Operation - Model H38DF-ST
with Continuous Pilot
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.

Lighting Instructions:

to "OFF."
NOTE: Gas control knob cannot be turned from
"PILOT" to "OFF" unless knob is pushed
in slightly. Do not force.

To Turn Off Gas To Appliance:

H(L)38DF-ST See-thru indoor Gas Fireplace
If you cannot reach your gas supplier, call the Fire
Q
Department.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
7. Push in gas control knob completely and hold. Light with Piezo
Igniter button. Continue to hold the control knob in for about
(1) minute after the pilot is lit. Release the knob and it will pop
back up. Pilot should remain lit. If it goes out repeat steps 3
through 8.
If knob does not pop up when released. Stop and
Q
immediately call your service technician or gas
supplier.
If the pilot will not stay lit after several tries, turn the gas
Q
control knob to "OFF" and call your service technician
to
or gas supplier.
8. Push in gas control knob and turn
counter-clockwise
9. Replacethe lower Horizontal access
panel.
3. Push in gas control knob slightly and turn
"Off". Do not force.
4. Replace the lower Horizontal access panel.
to "ON."
clockwise to
Page 19