Speaker Setup - Sony DVP-SR650P Operating Instructions Manual

SPEAKER SETUP

To obtain the best possible surround sound,
set the size of the speakers you have
connected and their distance from your
listening position. Then use the test tone to
adjust the volume of the speakers to the same
level.
This setting is effective when connecting the
speaker with AUDIO OUT (5.1CH) jacks
(page 11).
1
Select "SPEAKER SETUP" in the
Setup Display, then press ENTER.
SPEAKER SETUP
SIZE:
DISTANCE:
LEVEL(FRONT) :
LEVEL(REAR) :
TEST TONE:
FRONT:
CENTER:
REAR:
SUBWOOFER:
2
Set the following items in the
order that they are explained
below.
The default settings are underlined.
To return to the default setting
Select the item, then press CLEAR. Note that
only the "SIZE" setting does not return to the
default setting.
◆ SIZE
Selects the size of the speakers.
• FRONT
LARGE Normally select this position.
SMALL Select this when the speaker
cannot reproduce adequate bass
frequencies.
• CENTER
LARGE Normally select this position.
SMALL
Select this when the speaker
cannot reproduce adequate bass
frequencies.
NONE
Select this if you do not connect
a centre speaker.
OFF
LARGE
LARGE
LARGE
YES
• REAR
LARGE Normally select this position.
SMALL Select this when the sound
distorts or the surround effects
are difficult to hear.
NONE Select this if you do not connect
rear speakers.
• SUBWOOFER
YES
Select this if you connect a
subwoofer to output the LFE
(Low Frequency Effect) signals
from the subwoofer.
NONE Select this if you do not connect
a subwoofer.
b
• The cut off frequency for the subwoofer is fixed at
120 Hz.
• If your speakers are too small to reproduce low
bass frequencies, utilize a subwoofer for low
frequency sound. When you set the speaker
settings to "SMALL," the bass redirection
circuitry will be activated and the bass
frequencies for the speakers are output from the
subwoofer.
• Even if there are fewer than 6 speakers connected,
the player distributes the audio signal components
to the front speakers.
◆ DISTANCE
Sets the distance from your listening position
to the speakers.
Change the "Distance" setting each time you
move the speakers. Start from the front
speakers. The default adjustments are in
parentheses.
FRONT Set this between 1 and 7 m
(3m)
in 0.2 m increments.
CENTER (3m)
Set this within –1.6 and
+0.6 m of the "FRONT"
setting in 0.2 m increments.
For example, if "FRONT"
is set to 6 m, "CENTER"
can be set between 4.4 and
6.6 m.
REAR (3m) Set this within –5 and
+0.6 m of the "FRONT"
setting in 0.2 m increments.
For example, if "FRONT"
is set to 6 m, "REAR" can
be set between 1 and 6.6 m.
35
,continued