KitchenAid KUID308ESS Installation Instructions Manual page 6

Rear Panel
A. Screw locations
3. Remove the old drain tube and clamp attached to the ice
maker bin.
NOTE: Discard old drain tube and clamp.
4. Install new drain tube (⁵⁄₈" I.D. x 5¹⁄₈") from ice maker bin to
drain pump reservoir inlet using new adjustable clamps. See
"Drain Tube" illustration.
NOTES:
Do not kink.
Trim tube length if required.
Drain Tube
⁷⁄₈
A. " adjustable hose clamp
B. Drain tube (ice bin to drain pump)
5. Install vent tube (⁵⁄₁₆" I.D. x 32" [81 cm]) to drain pump
reservoir vent. Use one of the supplied ⁵⁄₈" small adjustable
clamp. See "Parts Locations" illustration.
NOTE: Do not install household drain tube at this time.
6
A
A
A
B
C
D
⁷⁄₈
C. " adjustable hose clamp
D. Drain pump reservoir inlet
Parts Locations
C
G
F
A. Vent tube
⁵⁄₈
B. " hose clamp
C. Drain pump discharge tube
D. Drain pump
6. Remove power cord clamp and ground screw attached to ice
maker power cord, which is mounted to the unit base. See
"Parts Locations" illustration.
NOTE: Clamp and screw will be reused.
7. Slide drain pump into the ice maker base on the right side.
The pump mounting tab should slip into the rectangular slot
in the ice maker base. It will be necessary to tip the pump
slightly to slip into the slot. See "Drain Pump Mounting Tab
Slot" illustration.
Drain Pump Mounting Tab Slot
A. Mounting tab slot
Drain Pump Installed
A. Drain pump installed
A
B
D
E
E. Ice maker unit power cord
³⁄₈
F. #8-32 x " pump
mounting screws
G. Drain pump power cord, clamp
and screw
A
A