Mitsubishi DY-1MU3E21-T Service Manual page 9

DISASSEMBLING PROCEDURES
● Disassembling procedures
In reverse of assembling procedures.
● Assembling procedures
1. Lock connector after inserting M001 to the connector of S2-DY as figure below.
Then insert reverse side to M001 and lock the connector.
2. Screw M014 and S2-DY with Ⓒ. (4 places)
3. Stick M009 on M014. (Follow lower right figure)
4. Insert 2 tabs of M005 to the rectangle hole of S2-DY,
and fit tabs on the 2 sides of M005, the screw M005 with Ⓐ.
M009 : SHEET-HS
M014
M014
M001 : FLAT-CABLE 18P
S2-DY
Ⓐ x 2
M005 : COVER-U
Ⓒ x 4
M014 : CD8-MECHA(955823)
M009 : SHEET-HS
9
Copyright (C) Mitsubishi Electric Corporation.
M001 : FLAT-CABLE 18P
M009 M014
M009 M014
M014 : CD8-MECHA(955823)
Tighten torque(N・m)
No. Screw
Ⓐ
3X6 0.8 +0.2/-0.1
Ⓒ
2.6X6S 0.6 +0.2/-0.1
Your company internal use only.
DY-1MU3E21-T