Switching Off; Care And Maintenance - Russell Hobbs 18941 Series Instructions And Warranty

Paddington kettle
Table of Contents

Advertisement

SWITCHING ON
Caution: Keep clear, as steam will escape from the spout when boiling.
Plug the power cord into the wall power outlet and switch it on.
Place the kettle on the base – take care not to spill any water.
Press the ON / OFF switch down, the light in the switch will illuminate.
The kettle will heat up.

SWITCHING OFF

When the water boils, the kettle will switch itself off and the light in the switch will go out.
To switch off manually, lift the ON / OFF switch or lift the kettle from the base and replace it.
The ON / OFF switch will pop up automatically.
Switch off the wall power outlet and remove the plug from the socket.
GENERAL
Remove the kettle from the base before pouring.
To avoid the risk of splashing, pour slowly and do not over-tilt the kettle.
Do not tilt the kettle backwards as water may seep into the control area.
If this happens, empty any remaining water and allow the kettle to dry before further use – sit
it aside in a warm, dry location for at least 12 hours.
When you lift the kettle, you may see moisture on the base. This is the steam used to switch
the kettle off automatically, which then condenses and escapes via vents under the kettle.
This is normal.
USING WITH INSUFFICIENT WATER
Using the kettle with insufficient water will shorten the life of the element.
If the kettle is accidently switched on when it does not contain sufficient water, a boil-dry
cut-out will switch the kettle off.
Sit the kettle on a stable heat resistant surface until it has fully cooled down.
Do not fill the kettle with water until it is cold, or it may spit.

CARE AND MAINTENANCE

Check that the kettle is switched off by lifting the kettle from the base and replacing it.
Switch the power off and remove the plug from the wall power outlet.
Allow the kettle to cool down fully.
Wipe over the outside of the kettle and base with a damp cloth. A mild dishwashing
detergent may be used if required.
Keep all connectors and sockets dry.
Do not immerse the kettle or base in liquid.
Do not use alkaline cleaning agents or harsh abrasives when cleaning this appliance.
Clean the inside of the kettle using the instructions in the "DE-SCALE REGULARLY" section.

Advertisement

Table of Contents
loading

Table of Contents