Nozzles; Replacing The Rear Window Wiper Blade; Windscreen Washer - Alfa Romeo GIULIETTA Owner's Handbook Manual

37)
"Service position"
Function activation
The "Service position" function allows
the driver to replace the windscreen
wiper blades more easily, protecting
them from snow.
To activate this function disable the
windscreen wiper (ring nut A fig. 191 in
position O) before turning the ignition
key to STOP.
This function can only be activated
within 2 minutes from when the ignition
key is turned to STOP.
191
To activate this function, move the lever
upwards (unstable position) for at
least half a second.
214
Each time the function is activated
correctly, the blades move to signal the
correct reception of the command.
This command can be repeated up to a
maximum of three times. After that the
function is disabled.
If after using this function the key is
brought back to MAR-ON and the
blades are not in the stop position,
these will be brought in the 1st speed
stop position only after a command
given through that lever (moving the
lever in unstable position) or when
5 km/h are exceeded.
Function deactivation
The function is deactivated if:
❒ two minutes have passed since when
the ignition key has been taken to
STOP;
❒ the ignition key is turned to MAR-ON
and the blades are in the stop
position;
❒ is activated 3 times.
A0K0557
Replacing the rear
window wiper blade
Proceed as follows:
❒ raise cover A fig. 192, undo nut B
and remove arm C;
192
❒ correctly position the new arm, fully
tighten the nut B then lower the
cover A.

NOZZLES

Windscreen washer

The windscreen washer nozzles are
fixed fig. 193.
193
A0K0533
A0K0139