Rear Blower Installation - Travis Industries 1750 Owner's Manual

Rear Blower Installation (Part # 99000138)
The rear blower improves heat transfer by pushing heated air through the convection channel. Operating
instructions are described in the section "Blower Operation".
a
Bend the legs on the snap
disk assembly until it is
approximately 1-5/8" thick.
This will help it fit tightly into
the rear convection channel.
1-5/8"
f
Attach the blower to the stove with the
three screws included with the blower.
3/8" Wrench
Plug the blower in. Do not route the power cord under or over the stove or in a
g
location where it may become damaged.
© Travis Industries
Optional Equipment
Remove these two knock-outs on
the bottom of the stove (use a
screwdriver to pry them out).
d
Attach the wires from
the thermodisk to the
wires from the blower.
e
Position the blower near the rear of the stove. Tuck all excess wire into the
blower box, making sure it does not contact any moving parts. Make sure when
installing the blower, these wires do not become loose.
b
100-01179
c
Twist the wires together on the snap disk
assembly. Wedge the snap disk into the
rear convection channel. Make sure the
snap disk contacts the firebox (not the back
of the convection jacket).
35
4060926