Travis Industries 1750 Owner's Manual page 30

Hide thumbs Also See for 1750:

Table of Contents

Air Tube Removal & Replacement

All three air tubes are identical.

Air Tube

Baffle Removal & Replacement

Push the front firebricks up and feed them forward, guiding them out the door. Repeat for the

rear firebricks.

Front Baffle Support

Front Air Tube

The baffle supports rest on support tabs.

The bypass support and damper are difficult to remove and should only be removed if necessary.

Remove the rear secondary air tube (see the following section for instructions). Slide the bypass

support forward until the bypass rod can be disconnected from the bypass damper. Slide the

damper forward and remove. The bypass support is removed by sliding it forward and rotating it

downwards (the bypass holder fits very snug inside the firebox and is very heavy, making it

difficult to remove). The bypass gasket rests on the side and rear air channels. Try not to

damage it when removing the bypass holder.

Maintaining Your Appliance

Air Tube Collar

Baffle Firebrick

Support Tabs

100-01179

Remove the left pin on the air tube collar

Roll Pin

Slide the air tube to the left, swing it

down and remove from the firebox.

Center Baffle Support

Baffle Plate

Baffle Plate Support

Baffle Plate Gasket

4060926

Table of Contents