Dispenser - LG LSC26905TT Service Manual

HOW TO DISASSEMBLE AND ASSEMBLE

7. DISPENSER

1) Disconnect funnel and button assembly by pulling down
and forward.
Button
2) Remove the Display Frame by pressing a screwdriver
between the Frame and the Door and pulling it forward.
Insert the screwdriver at the bottom (see drawing,
below.) The Frame is attached by hooks at the top. Pull
the bottom out and lift the frame up.
3) The Display Assembly can be connected by pressing
the top of the Dispenser Cover and pushing it after
separating the Display Frame from its housing.
4) Loosen four screws with a phillips screwdriver and pull
the Funnel Assembly to disconnect.
Funnel Assembly
5) The Duct Cap Assembly can be disconnected if the hold
lever connecting screw is loosened with a phillips driver.
6) To install the Duct Cap Assembly, insert one end of the
spring into the right hole of the dispenser lever and
insert the other end into the right hole in the top part of
the dispenser. Then attach the holder at the solenoid
switch.
Solenoid Assembly
- 141 -
Funnel
Assembly
Solenoid Assembly
Holder
Lever
Duct Cap
Assembly
Sheet Heater
Spring
Dispenser Lever