Advertisement
Ceiling Mount of Unit Body
1.
Initial Installation of Indoor Unit
Attach the suspending frame base to the suspending bolt. Nuts and washers must be used at the upper and
lower sides of the suspending frame base to secure it. The locating plate
off.
Refer to the installation paper mould
The installation paper mould marks the center of the ceiling opening.
The label of the unit and the installation paper mould all mark the center of unit.
Use screw
(3 pieces) to install the installation paper mould
drainage groove at the outlet of the pipe.
2.
Adjust the position of the unit so that it is in the correct installation position (refer to Figure 3)
3.
Check if the unit is horizontal
The indoor unit is equipped with built-in draining pump and level tube
In case the unit inclines toward the direction opposite the flow direction of condensate water, the float switch
may suffer from failure, so that dripping is caused.
4.
Remove the washer locating plate
5.
Remove the installation paper mould.
Tightening (Double Nuts)
(Secure the suspending frame base)
Level Tube
Polyethylene pipe
Warning : Please tighten the nuts and bolts to prevent them from dropping.
for preventing the washer from falling off. Tighten the nut on it.
Nuts (provided by user on site)
Washer (accessory)
Suspending Frame Base
Center of Ceiling Opening
Screw
for the dimensions of the ceiling opening.
to the unit and use screws to fix the angle of the
The screw beside the pipe outlet is secured
at the corner of the drainage groove
(accessory)
(Secure the Installation Paper Mould)
44
can prevent the washer from falling
Inserting In
Locating Plate of Washer
(Secure the washer)
Installation Paper Mould
Screw
(accessory)
(accessory)
Advertisement
