Toshiba e-Studio 224cs User Manual page 144

(f) Replace fuser unit into the machine and move locking levers (e) toward the rear
of the machine.
NOTE
Check that there is no paper remaining inside the machine.
Remove the paper carefully so that it does not tear. If the paper tears, be sure
to remove all of the pieces.
7. If you were duplex printing when the jam occurred, check the duplex paper path:
(a) Pull the locking levers at each side of the transfer belt up and towards the front
of the machine.
(b) Using the locking levers (a), lift the belt (b) upwards and withdraw from the
machine.
(c) Look into the printer to check whether any sheets of paper are visible on any
part of the paper path. Pull out any sheets found in this area.
e
b
Troubleshooting > 144
e
a
a