Section 9. Attaching The Tail Wheel - Hangar 9 Extra 330L Instruction Manual

Section 9: Attaching the Tail Wheel
Parts Needed
• Fuselage
Included in Optional Hangar 9's Hardware Package
• Large Tail Wheel Assembly (Ohio Superstars #OHI130)
Not Included
3
• (2) #6 x / " Sheet Metal Screws (DUB386)
4
Step 1. Assemble the tail wheel
per the instructions included with
the tail wheel assembly. The nylon
control horns included with the tail
wheel assembly are not used.
Step 2. Position the tail wheel
in place as shown, centered on
the rear of the fuselage. Using a
pen, accurately mark the two
hole positions through the tail
wheel bracket.
Step 3. Remove the bracket and drill
previously marked positions.
24
1
/ " pilot holes at the
8
Tools and Adhesives Needed
• Phillips screwdriver
1
• Drill with / " drill bit
8
• Pen
3
Step 4. Using two #6 x / " sheet metal screws, fasten the
4
tail wheel bracket in place. Note that a hardwood plate is
positioned in the rear of the fuselage, allowing these screws to
be firmly tightened.
3
Hint: Remove the #6 x / " screws and wick thin CA into
4
the holes to strenghten the threads. When dry,
reinstall the screws.
Step 5. Using the provided spring, hook up the tiller arm to the
rudder per the instructions included with the tail wheel.