Section 12. Hatch Assembly - Hangar 9 Extra 330L Instruction Manual

Section 11: Mounting the Engine and Cowl
Step 5. Optional muffler BIS07163 is recommended. Install
the muffler.
Step 6. Using a Moto-tool with a cut-off wheel and a drum
sander, cut an air outlet in the bottom of the cowl as shown. The
approximate size should be 5" x 5". It may also be necessary to
cut out an area for the mufflers to exit, depending on the mufflers
and engine you use.
Section 12: Hatch Assembly
Parts Needed
• Hatch (HAN1210)
• Canopy (HAN1209)
3
• (2) 4-40 x /
4
#4 Washers (HAN1214)
• Decals for instrument panels or optional
Hangar 9 Scale Panels (HAN185)
Not Included
• 1/3 Scale Pilot (HAN8265)
Step 1. Glue a 1/3 scale pilot in the rear seat area (silicone glue
works good here) and attach the instrument panels. Hangar 9
offers sharp looking Extra Instrument Panels (HAN185) that
replace the decals for a scale look.
30
" Screws with Split Washers and
Tools and Adhesives Needed
• Scissors
5
• / hex wrench
32
• Canopy Glue (Pacer Formula 560 or equivalent)
(PAAPT56)
• Silicon glue (3M caulking)
• Masking tape
CONTINUED