Programming In 24 Hour Mode; Programming In A+B Mode - Danfoss FP735Si User Manual

1.7.4 Programming in 24 hour mode

(Every day of the week uses the same programme)
a) Press the PROG button until event 1 fl ashes (Fig. 17).
b) Amend the time as follows:
GB
i) Press the + and – buttons to alter the time (press and hold to
move in 10 minute increments).
ii) Press the NEXT button to advance to the next event (Fig. 18).
iii) Repeat the steps above for the remaining events.
c) When all events are programmed press the PROG button to
return to RUN mode (Fig. 19).

1.7.5 Programming in A+B mode

(The Advanced Programming parameter 6
Press and hold the PROG and V buttons for 3 seconds.
The display will change to that shown in Fig. 20. This
will take you into Advanced Programming Mode
option 1.
Use the Λ or V buttons to enable or disable the
function (1=enabled, 0=disabled).
14
Fig. 17
must be set to 5+2 days)
Fig. 18 Fig. 19
Fig. 20
FP735SI