Pppoe - Planet Networking & Communication ICA-601 User Manual

Password The password is used to log into DDNS.

3.5.3 PPPoE

PPPoE: Stands for Point to Point Protocol over Ethernet
A standard builds on Ethernet and Point-to-Point network protocol. It allows ICA-601 / ICA-651
connect to Internet with xDSL or cable connection; it can dial up your ISP and get a dynamic IP
address. For more PPPoE and Internet configuration, please consult your ISP.
It can directly connect to the xDSL, however, it should be setup on a LAN environment to program
the PPPoE information first, and then connect to the xDSL modem. Power on again, then the
device will dial on to the ISP connect to the WAN through the xDSL modem.
The procedures are
• Connect to a LAN by DHCP or Fixed IP
• Access the device, enter Setting
PPPoE
User Name
Password
IP Address, Subnet
Mask, and Gateway
Status
Network
To enable or disable the PPPoE service here.
Type the user name for the PPPoE service which is provided by ISP.
Type the password for the PPPoE service which is provided by ISP.
Shows the IP information got from PPPoE server site.
Shows the Status of PPPoE connection.
45
PPPoE as below