Installation - AEG FAVORIT 99015 IM0P User Manual

20 www.aeg.com

12. INSTALLATION

There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water
tap and drain.
For the venting of the appliance only wa-
ter hoses and mains cable openings are
necessary.
Adjusting the level of the
appliance
A correct adjustment of the level of the
appliance allows the door to close and
seal correctly.
If the door does not close correctly,
loosen or tighten the adjustable feet to
level the appliance.
12.1 Water connection
Water inlet hose
Connect the inlet hose to a water tap
with an external BSP thread spout of
3/4".
For best washing performance it is rec-
ommended to connect the appliance to
a cold water supply.
The hose s hould not be
extended by more than
2 metres or water pump-
out problems ma y occu r
Secure dishwasher with
brackets and screws provided
Gap on both sides should be
equal, & no greater than
5 mm per side.
• K ickplate fixing screws
If floor is not level, adjust
levellin g legs to suit
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
600 mm max.
300 mm min.
•
Energy savings can be made by connect-
ing the appliance to a Solar water sys-
tem and using economy options, howev-
er the water temperature must not ex-
ceed 60 °C.
Inlet water supply
• Water pressure: 800 kPa max - 50 kPa
min.
• Water flow rate 10 L / minute min.
• If water pressure is in excess of 800
kPa, a pressure reducing valve should
be used. Check for leaks.
• If water temperature is in excess of 60
°C, a tempering valve should be used.
Check for leaks.
CAUTION!
Always use new hoses when you
connect the appliance to the wa-
ter mains. Old hoses must not be
used. The water inlet hose must
be examined at an interval of
twelve months for deterioration
and replaced if necessary.
The water pressure must be in the limits,
refer to "TECHNICAL INFORMATION".