Lighting The Side Burner - Brinkmann 810-2511-S Owner's Manual

MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
2. Make sure all control knobs are in the "OFF" position.
3. Remove the matchlighter located in the upper panel of the cart front as
illustrated.
4. Place a paper match in the end of the matchlighter. Strike the match and
place through the cooking grate approximately 1/2" (1 to 2 cm) from the
burner to be lit.
5. Turn the burner control knob to the "HIGH" position. The burner should light within 5 seconds.
6. If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure.
7. Once lit, light adjacent burners by following steps 4-6.
8. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected.
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners
manual.

LIGHTING THE SIDE BURNER:

1. Open lid before lighting side burner.
2. Make sure control knob is in the "OFF" position.
3. Push and hold down side burner control knob and SLOWLY
(2 to 3 seconds) turn to "HIGH". You should hear the igniter click.
Note: Step 3 may need to be repeated 2-3 times to light side burner.
4. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait
5 minutes to allow gas to dissipate and repeat lighting procedure.
5. If burner does not ignite using the igniter, see "Match Lighting the Side Burner" section.
6. To turn off, turn control knob clockwise until it locks in "OFF" position.
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners
manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to "OFF".
3. Remove the matchlighter located in the upper panel of the cart front.
4. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.
5. Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.
6. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
7. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected.
Note: If burner does not light or flame is too low, See "Trouble Shooting"
section of the owners manual.
Note: Observe flame height when lit: Flame should be a Blue/Yellow color
between 1"–2" when burner is on "HIGH".
See section in manual on burner adjustment to adjust flame.
Matchlighter
10