Lighting The Side Burner - Brinkmann Ranger Assembly And Operation Instructions Manual

5 . To light other burner, push and turn control knob to "HIGH" .
6 . If burner does not ignite using the igniter, see "Match Lighting the Main Burners" section .
7 . To turn off, turn each control knob clockwise until it locks in the "OFF" position . This does not turn off the
gas flow from the cylinder.
Note: I f burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.
match lighting the main burners:
1 . Open lid before lighting .
2 . Make sure all control knobs are in the "OFF" position .
3 . Place a paper match in the end of the matchlighter . Strike the match and
place through lighting hole in the left hand side of the grill to approximately
1/2" (1 to 2 cm) from the burner.
4 . Turn on the left main burner control knob to the "HIGH" position . The
burner should light within 5 seconds .
5 . If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure .
6 . To light other burner, push and turn control knob to "HIGH" .
7 . If the burner does not light within the first few attempts of match lighting, there is
a problem with the gas supply . Turn off the gas at the burner and cylinder . do not attempt to operate
the grill until the problem is found and corrected .
Note: I f burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.

lighting the side burner:

1 . Open lid before lighting side burner .
2 . Make sure control knob is in the "OFF" position .
3 . Push and hold down the SIDE BURNER control knob and turn
SLOWLY (2 to 3 seconds) to "HIGH" . You should hear the igniter click .
Note: Step 3 may need to be repeated 2-3 times to light grill .
4 . If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait
5 minutes to allow gas to dissipate and repeat lighting procedure .
5 . If burner does not ignite using the igniter, see "Match Lighting the Side Burner" section .
6 . To turn off, turn control knob clockwise until it locks in "OFF" position .
Note: I f burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.
match lighting the side burner:
1 . Open lid before lighting side burner .
2 . Make sure control knob is in the "OFF" position .
3. Strike the match and place it approximately 1/2" (1 to 2 cm) from the burner.
4 . Push and turn the side burner control knob to the "HIGH" position . The
burner should light within 5 seconds .
5 . If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure .
6 . If the burner does not light within the first few attempts of match lighting, there is a problem with the gas
supply . Turn off the gas at the burner and cylinder . DO NOT attempt to operate the side burner until the
problem is found and corrected .
Note: I f burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.
Note: Observe flame height when lit: Flame should be a Blue/Yellow color
between 1"–2" when burner is on "HIGH".
see section in manual on burner adjustment to adjust flame.
Lighting Hole
Matchlighter
10