L Iste N In G To Aux De Vice S - iHome iPL23 User Manual

U SI NG T H E R AD I O I N OT H E R CO UNT R I E S
Different regions of the world use different FM radio frequency steps and
ranges. You will need to select the one that matches the standards in your
region (USA, EUROPE, JAPAN, AUSTRALIA, or CHINA). The default setting is
USA; if you live in the US, you may skip this section.
1. Press and release the
release the Mode Button as needed to cycle to FM radio mode.
2. Press and hold the Mode Button for about 5 seconds until the region
flashes in the display and a beep sounds.
3. Press the + or – Buttons as needed to set the display to your region: USA,
EU (Europe), JPN (Japan), AUS (Australia), or CHN (China).
2. Press and release the Mode Button (or no button within 10 seconds) to
exit the radio frequency setting mode. Two beeps will confirm radio
frequency setting.

L ISTE N IN G TO AUX DE VICE S

1. Connect a standard stereo audio cable with 3.5mm plug to the headphone
or line-out jack on your AUX device and the other end to the AUX IN jack
located on the back of the iPL23.
2. Press and release the
release the Mode Button as needed to cycle through dock (iPod), FM radio
and AUX modes.
3. When AUX mode is selected, turn on your AUX device and use its controls
to play, pause and navigate audio tracks. Adjust the volume on your AUX
device to maximum output.
4. Press the or
5. Press and release the
listening. Remember to turn off your AUX device, too.
Power Button to turn on the unit, then press and
Power Button to turn on the unit, then press and
Button on the unit to adjust the system volume.
Power Button to turn off the unit when through
9