Table of Contents
Advertisement
Projecting Images
Correcting Distortion in the Projected Image
The following operations explain how to correct distortion in projected
images and how to switch between correction methods.
Control panel
Press the [
] button. The selected correction method is executed. To
change the correction method, press the [
the [Esc] button.
Remote control
Perform in Geometric Correction from the Configuration menu.
Press [Menu] button > Settings > Geometric Correction
a
• When correcting distortion in the projected image, the screen size is
reduced.
• You cannot combine multiple adjustment methods. However, you
can use Point Correction after performing Curved Surface or Corner
Wall.
H/V-Keystone
Manually correct distortion in the horizontal and vertical directions
independently.
] button, and then press
Correction range
When the lens shift is in the center, distortion can be corrected when the
angle of vertical and horizontal tilt of the projector is up to 30 degrees
against the screen (19 degrees when using the short throw zoom lens
ELPLU01).
Operations
a
Select H/V-Keystone from Geometric Correction.
b
Use the [
][
] buttons to select the correction method, and
then use the [ ][ ] buttons to make the corrections.
43
Advertisement
Table of Contents
