Table of Contents
Advertisement
DX0.5
Routing
The routing tab allows you to configure the routing from the two input channels to the six output;‐
This page also allows quick access to the pages for other adjustments;‐
Clicking on any other the input or output boxes will bring up the output naming window.
Clicking on any of the Gain or Limiter boxes will open the Gain/Mute/Lim tab.
Clicking on a Polarity or Delay box will take you to the Delay Tab.
Clicking on PEQ or X‐over will open the input or output channel tab depending on which box is clicked.
The routing from inputs A and B will be pre‐determined by your choice of system configuration but can be freely modified to suit
your requirements by simply clicking on the nodes to show a tick. Not that all outputs must have at least one input routed, they
cannot be left un‐routed (but can of course be muted if you don't need to use a channel). Both nodes can be clicked to run the
output channel from a mono signal derived from both input channels;‐
HAM09224 User Guide V1.0
USER GUIDE
46
Advertisement
Table of Contents
