Table of Contents
Advertisement
DX0.5
The Nav/Edit1 rotary encoder control allows you to navigate the user interface, edit sections of the processor, navigate within
screens to select sub‐menus, pages and parameters, as well as select values during editing.
8. Edit2 Control
The Edit2 rotary encoder control allows you to edit parameters, as well as select values during editing.
9. Edit3 Control
The Edit3 rotary encoder control also allows you to edit parameters, as well as select values during editing.
In general, use the Nav/Edit1 rotary encoder control to scroll through the various pages and configuration settings. Depending
on the page, individual parameters may be changed by turning one (or more) of the encoders. In some cases, the Edit2 and Edit3
controls provide fine and course control of the same parameter.
10. Enter Button
The Enter Button allows you to dig deeper and deeper into menus and parameters, confirm operations and change settings.
11. ESC Button
The ESC Button allows you to retreat from selected variables. In some cases, it confirm operations and changes settings, as well.
These will be noted.
12. Utility Button
Press this button to select and update the DX0.5's utilities. There are three main utilities menus:
System Utilities
Preset Utilities
Security Utilities
Within each, an array of sub‐menus are available.
13. Mute / Edit Buttons
These eight buttons serve a dual purpose:
Muting selected inputs and outputs
Editing selected inputs and outputs
To mute an input or output, quickly press and release the desired button once to engage mute; quickly press and release it again
to un‐mute. Mute as you might expect toggles between muted and unmuted on the corresponding inputs and outputs.
To edit an input or output, press and hold the desired button until that input or output's blue LED [14] illuminates. Press and
hold again to take it out of edit mode. Edit allows you to edit – change – variables on the chosen inputs and outputs. While it is
not possible to edit the inputs AND outputs simultaneously, it is possible to link and edit the inputs simultaneously OR link and
edit any number of outputs simultaneously. Simply press and hold any additional input or output Mute / Edit buttons to link. Any
changed parameters will affect all linked inputs or outputs.
14. Edit LEDs
There are a total of eight Edit LEDs on the DX0.5: two input and six output. Edit LEDs illuminate blue when engaged. See Mute /
Edit Buttons [13].
15. Mute LEDs
There are a total of eight Mute LEDs on the DX0.5: two input and six output. Mute LEDs illuminate red when engaged. See Mute
/ Edit Buttons [13].
16. Meters
HAM09224 User Guide V1.0
USER GUIDE
15
Advertisement
Table of Contents
