Powered Arrayable Loudspeakers And Subwoofers - Martin Audio DX0.5 User Manual

DX0.5
Powered Arrayable Loudspeakers and Subwoofers
Here, the DX0.5 is configured using the '2xStereo+Subs' setup type. The left and right line‐level XLR outputs of a mixer feed the
A and B XLR inputs of the DX0.5 Loudspeaker Management system.
XLR outputs 1, 2, 3 and 4 of the DX0.5 feed the XLR inputs of a pair of MA3.0 amplifiers. The CH 1 and CH 2 NL4 speaker outputs
of these power amplifiers feed the Phoenix inputs of the top and bottom of a stereo pair of 16 module Omniline arrays
XLR output 5 of the DX0.5 is connected to the A & B XLR main inputs of a Martin Audio MA5.2K; it is only necessary to connect a
cable to input A as the amplifier has a link switch to parallel both inputs. The CH 1 and CH 2 NL4 speaker outputs of this power
amplifier feed the Phoenix input of a pair of CSX212 passive subwoofers
The DX0.5's high‐ and low‐pass filters on output channels 1–5 may be configured to create a crossover to optimize the
subwoofers with the Omniline. The subs are run mono by properly configuring the input sources for DX0.5 output 5. The DX0.5
may be used for adding the PEQ recommended by the Omniline software and any additional room corrective EQ. Delay to align
the loudspeakers and subwoofers can be added and a limiter for protection of the system.
HAM09224 User Guide V1.0
USER GUIDE
13