Table of Contents
Advertisement
WALRB4P manual booklet
INSTALLING BATTERIES
1.
On the remote control's back, push the tab and lift off the
battery cover.
2.
Obtain two (2) new AAA alkaline batteries. Match the +
and – marks on the batteries to the + and – marks in the
battery case, then insert the new batteries.
3.
Press the battery cover back into place. The tab should
click when the cover is locked.
4.
Test the remote control by pressing any mode key (e.g.,
). If the batteries are inserted correctly, the
TV
light) will blink.
NOTE: When batteries need replacement, the remote control will stop operating. Remove
the old batteries and insert new ones within 10 minutes to ensure all of your programming
information is restored.
5/2/06
3:16 PM
Page 7
(red
LED
7
PROGRAMMING DEVICE CONTROL
The One For All 4 Device Universal Remote Control is preprogrammed at
the factory to operate an RCA TV, a Toshiba DVD player, a Motorola cable
box, and an RCA VCR. To control devices other than the default brands, per-
form the following steps; otherwise skip this section:
1.
Turn on a desired device (e.g.,VCR or DVD player) and, if
applicable, insert media (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely before proceeding.
Highlight or write down the codes and device you wish to program
before starting step 2.
2.
On the remote control,press a device key once (i.e.,
,
,or
).
DVD
CBL/SAT
TV
NOTE: To program control of a VCR, PVR (or DVR), TV/VCR Combo,
or TV/VCR/DVD Player Combo press VCR/PVR once. After program-
ming a VCR Combo device, you will be able to control channel selec-
tion, volume, and VCR functions.
NOTE: To program control of a DVD Player, DVD Player/VCR
Combo, or TV/DVD Player Combo, press DVD once. After program-
ming a DVD Combo device, you will be able to control channel selec-
tion, volume, and DVD functions.
NOTE: To program control of a Cable Box, Cable Box/PVR (or DVR)
Combo, Satellite Receiver, or a Satellite Receiver/PVR (or DVR)
Combo, press CBL/SAT once.
3.
Press and hold
until the
SET
then release
.
SET
4.
Use the Manufacturer's Codes (starting on page 36) to
locate the type of device and brand name and then enter
the first four-digit code for your device. If performed cor-
rectly, the
will blink twice.
LED
NOTE: If the LED did not blink twice, repeat steps 2 through 4 and enter
the same code again.
5.
Aim the remote control at the device and press
once. The device should turn off. If it does not, repeat
steps 2 through 5, trying each code for your brand until
you find one that works. If it still doesn't work, try
Searching For Your Code on next page.
NOTE: If the device does not have a POWER key, press PLAY.
6.
Repeat steps 1 through 5 for each device you want to con-
trol.For future reference,write down each working device
code in the following boxes:
Code:
VCR/PVR
Code:
DVD
Code:
CBL/SAT
Code:
TV
VCR/PVR
(red light) blinks twice,
LED
POWER
Device Type:______________
Device Type:______________
Device Type:______________
Device Type:______________
8
,
Hide quick links:
Advertisement
Table of Contents
