Installing The Batteries; Features And Functions - One for All URC-6210 Instruction Manual

The ZAPPER needs 2 new "AAAA" alkaline batteries.
1 Remove the battery cover from the back of the ZAPPER by pressing down on
the tab.
2 Match the batteries to the +/- marks inside the battery case, then insert the
batteries.
3 Press the battery cover back into place.
Important notes:
- In order to avoid having to reprogram your ZAPPER after you
remove the batteries, you will need to insert new batteries within
5 minutes. Also, it is best that you do not use rechargeable batteries.
1 POWER (red LED – Light Emitting Diode)
The POWER key operates the same function it did on your original remote
control. The LED underneath the POWER key will light up red whenever a
key is pressed.
2 CHANNEL +/-, VOLUME+/- and MUTE
The CH+/- and VOL+/- keys operate just as those on your original remote
control. These keys are also used to set up your ZAPPER.
3 MAGIC
The MAGIC key (= setup key) is used to set up your ZAPPER.
WWW.ONEFORALL.COM

Installing the batteries

Features and Functions

3