Table of Contents
Advertisement
S36
LCD Contrast
S37
Boat Show
S38
Factory Reset
SETUP HEALTH - Health Chapter
S39
Software Version/Network Nodes
If the display is a "Slave" (was switched on by the system) then the signal
strength to the "Master" will be shown in place of the number of nodes.
S40
Hull Transmitter Signal Strength
S41
Wind Transmitter Signal Strength
www.raymarine.com
Adjusts the viewing angle of the LCD display to improve
visibility under varied mounting possibilities
Available values are: 1 - 7 default 4.
Allows the display to show information when NOT installed
as part of a Micronet system for demonstration purposes
only.
Displays will return to default Off on power down.
Returns all the calibration setting to the factory default
values.
Displays the software version, battery level and charge rate
to assist in troubleshooting and fault finding.
If the display is the "Master" (the one used to switch on the
system) then the number of items (nodes) in the system will
be shown.
Shows the software version (large digits), signal strength
and battery condition (level and charge rate) of the Hull
Transmitter to assist in trouble shooting and fault finding
As above but for Wind Transmitter information.
Set-up and Calibration
27
Hide quick links:
Advertisement
Table of Contents
