Bc Controller Disassembly Procedure; Service Panel - Mitsubishi Electric PUHY-200YMF-C Service Handbook

[2] BC Controller Disassembly Procedure

(1) Service panel

Procedure
1. Remove the two screws securing the electric panel
box, and then remove the box.
2. Remove the four screws securing the front panel
and then remove the panel. Two of the screws are
not visible until you remove the electric panel box.
3. Remove the two screws securing the ceiling panel.
Next, lifting up on the panel slightly, slide it inwards
and then remove it. The inside of the ceiling panel
is hooked on a pin.
4. Remove the single screw that secures the side
panel, and then remove the panel.
Photos & Illustrations
Celling panel
BC
control-
Celling panel
ler unit
fixing screw
–113–
Be careful on removing heavy parts.
Pin