Sony PFM-510A1WU Service Manual page 13

Location and Function of Parts and Controls / Installation
Installing batteries
Insert two size AA (R6) batteries in correct polarity.
Be sure to
install the
negative <–
end first.
E
e
e
E
• In normal operation, batteries will last up to half a
year. If the Remote Commander does not operate
properly, the batteries might be exhausted. Replace
them with new ones.
• To avoid damage from possible battery leakage,
remove the batteries if you do not plan to use the
Remote Commander for a fairly long time.
When the Remote Commander does not work
Check that the 1 indicator lights up. The Remote
Commander operates the monitor only when the
monitor is turned on, or it is in the standby mode.
Note
If you connect the cable to the CONTROL S IN jack
on the side of the monitor, you cannot operate the
monitor with the Remote Commander.
12
(GB)
Installation
Using the Retractable Feet
This section describes the installation arrangements
for installing the projector.
1
Pull out the knobs and pull down the retractable
feet.
2
Turn the retractable feet outward.
3
Push in the retractable feet and lock.
To fix the retractable feet
When the unit is installed on the floor, be sure to fix
the retractable feet.
Install the foot support brackets as illustrated below.
Caution
• When you install the monitor, make sure there is
more space than that shown in the figure below.
• The ambient temperature must be 0°C – +35°C
(32°F – 95°F).
When using the retractable feet
Front
Wall
20 (7 7 / )
8
10 10
Wall Wall
(4) (4)
Floor
2.5 (1)
Side
5.5 (2 1 / )
4
Wall
Floor
Units: cm (inches)
When using the mounting bracket
Front
Wall
25 (9 7 / )
8
10 10
Wall Wall
(4) (4)
7
25 (9 / )
8
Wall
Installation
Side
3.5 (1 7 / )
8
Wall
Units: cm (inches)
Hooked on the wall: Vertically
Front
Wall
10 (4)
20 25
(7 7 / ) (9 7 / )
Wall 8 8 Wall
Make sure that
the control
section is at the
bottom.
10 (4)
Wall
Side
5 (2)
Wall
Units: cm (inches)
13
(GB)