Sony PFM-510A1WU Service Manual page 10

Location and Function of Parts and Controls
Location and Function
of Parts and Controls
Front / Sides
Front
1 2
Left side Right side
6
3
5
4
1 Retractable feet
Use for setting the monitor on the floor.
For details on using the retractable feet, see "Using the
Retractable Feet" on page 12 (GB).
2 Control panel
For details on the control panel, see "Control Panel" on
page 7 (GB).
3 Left panel cover
Open it when using the left connector panel.
You can install the Remote Commander in the back of
this cover.
For details on opening the panel cover, see the right on this
page.
4 Left connector panel
For details on the left connector panel, see "Left Connector
Panel" on page 10 (GB).
6
(GB)
5 Right connector panel
For details on the right connector panel, see "Right
Connector Panel" on page 8 (GB).
6 Right panel cover
Open it when using the right connector panel.
For details on opening the panel cover, see the below on
this page.
To open the panel cover
Loosen the screws counterclockwise and open the cover.
To take off the panel cover
Loosen the screws as illustrated below and take off
the panel cover.
Screws
To install the Remote Commander in the
panel cover
Install the Remote Commander in the back of the left
panel cover as illustrated below.
Remote
Commander
Note
When housing the Remote Commander, make sure
that the top of the Remote Commander faces upward
and rear faces outside.
Control Panel
VOL – VOL + MENU ENT RGB1
m M
qd qs qa 0 9
1 Remote control detector
Receives the beam from the Remote Commander.
2 1 (standby) switch/1 (standby) indicator
Press to turn the monitor on. Press again to go back to
the standby mode.
The 1 (standby) indicator lights up in red in the
standby mode.
When the 1 indicator flashes, see "Self-diagnosis
Function" on page 26 (GB).
3 Power indicator
Lights up when the monitor is turned on.
4 CTRL (control) button
To operate the buttons on the control panel, first press
this button. Then the buttons light up or flash that
show they can be operated. Press again to deactivate
them.
Note
The buttons (except for 1 (standby) switch 2) on the
control panel do not function if you do not press the
CTRL button first.
5 Y/C button
Select the signal input from the Y/C IN jack in the
LINE connectors.
6 LINE button
Select the signal input from the VIDEO IN connector
in the LINE connectors.
7 RGB2 button
Select the signal input from the RGB2 connectors.
8 YUV button
Select the component signal input from the RGB1
connectors.
Location and Function of Parts and Controls
YUV RGB2 LINE Y/C CTRL 1
8 7 6 5 4 3 2 1
9 RGB1 button
Select the RGB signal input from the RGB1
connectors.
0 ENT (enter) button
Press to select the desired item in a menu.
qa M/m buttons
Press to move the cursor (B) to an item or to adjust
value in a menu.
qs MENU button
Press to make the menu appear.
qd VOL (volume) +/– buttons
Press the + button to increase the volume, or the –
button to decrease the volume.
7
(GB)