Solution Filter Cleaning; Troubleshooting - Clarke CA30 20B Instructions For Use Manual

Clarke ca30 20b automatic scrubbers instructions for use
Hide thumbs Also See for CA30 20B:
Table of Contents

Advertisement

Available languages

Available languages

A - ENGLISH

SOLUTION FILTER CLEANING

1.
Drain all the water from Solution tank as previously outlined.
2.
Move the machine to a fl at and smooth surface.
3.
Press the power switch (41) to the "O" position to turn off the machine.
4.
Turn off the draining ball valve (A, Figure 17) (located at the bottom of the machine, behind the wheels). Position B ball valve open, and
position C ball valve closed.
5.
Remove the transparent cap (D), and then take off the fi lter (E), and install them onto the fi lter box (F) after cleaning.
NOTE
The fi lter (E) must be accurately installed onto the position of the housing (G).
6.
Open the draining ball valve (A).

TROUBLESHOOTING

Breakdown
Machine not working: Indication
light not on
Warning light (39 and 40) fl ashing
Brush not working
Vacuum motor not working
Inadequate Vacuum
Water supply to the brush
inadequate
Squeegee leaving marks
A - 18
INSTRUCTIONS FOR USE
FIGURE 17
Probable Cause
Battery connector (9) not connected.
Battery power already exhausted
Brush motor overloaded
Obstruction preventing brush from
spinning
Brush fuse trip off
Belt slipping
Vacuum fuse trip off
Recovery tank is full.
Drain hose and squeegee hose not properly
connected
Float fi lter blocked or inlet blocked
Squeegee dirty or squeegee blade worn
and damaged
Recovery tank lid not properly sealed, or the
seal / gasket for recovery tank damaged
Filter dirty
Debris fragments under the squeegee blade
Squeegee blade worn, cracked or brittle.
Balance of squeegee not adjusted
CA30 20B - 56091130
Remedies
Connect the battery connector
Charge the battery
Change to a soft brush to adapt to
the fl oor being cleaned
Clear the brush
Reset
Check belt, adjust tension
Reset
Drain the recovery tank
Connect the drain hose and the
squeegee hose
Clean the fl oat fi lter, check the fl oat
ball
Clean and check the squeegee
Refi t on the lid properly, replace the
recovery tank seal
/ gasket
Clean the fi lter
Remove the fragments
Replace the squeegee blade
Adjust the balance
7/2014

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

510b

Table of Contents