Displaying Tv Sratus Information; Understanding The Last Mode Memory Feature - Toshiba 40G300U Owner's Manual

Note: When you turn on the Audio Receiver,
change its input source, or adjust the sound
volume, the sound will be output from the audio
receiver's speakers even if TV Speakers has
been selected. Turn the TV off and on again to
output the sound from the TV speakers.
Speaker
Preference
From this item, you can set your audio
output preference to the TV speakers
or the audio receiver speakers. When
this item is set to Audio Receiver,
the TV remote can be used to adjust
or mute the volume of the audio.
This item will be grayed out unless
a REGZA-LlNK compatible audio
receiver is connected.
• Stereo, Mono or SAP audio status (when HDMI input
mode, Dolby Digital or PCM)
• Video resolution
• Aspect ratio of incoming video signal (4:3 or 16:9)
• V-Chip rating status
• Game Timer (if set)
1_.
C··t1iMi'Mnauiim
M
d4d1*
• : J '
To close the RECALL screen:
RECALL .
Press 0 agaill.
To display TV status information using INFO:
To set the REGZA-LINK® Setup:
1
From the
Setup
menu, highlight
REGZA-L1NK
Setup
and press
@.
2
Press. or
T
to highlight
Enable REGZA-L1NK.
3
Press .... or
~
to select
On.
Note: If you select
Enable REGZA-LINK
Off, the
other items will be grayed out.
4
Press. or
T
to highlight the
REGZA-L1NK Setup
item you want to use, and press .... or
~
to select
On
or desired mode.
• TV Auto Input Switch: On/Off
• TV Auto Power: On/Off
• Device Auto Standby: On/Off
• Speaker Preference: TV Speakers/Audio Receiver
5
To save the new settings, highlight
Done
and press
@.
To revert to the factory defaults, highlight
Reset
and press
@.
Displaying TV status information
To display TV status information using
RECALL:
RECALL
Press 0 on the remote control.
The following information will display (if applicable):
• Current input
(ANT/CABLE, VIDEO 1,
etc.)
• If ANT/CABLE is the current input, either "CABLE"
(for cable TV) or "ANT" (for over-the-air broadcasts).
• Channel number (if in
ANT/CABLE
mode)
• Channel label (if set)
• Digital signal strength indicator (bar graph in lower
right corner of box; for ATSC signal only)
58
INFO
Press 0 on the remote control.
The following additional information will display for
off air digital channels (if applicable):
• Title
• Duration
• Detailed description
MLB Young'5 XXX.. 9:00pm' 11.00pm EST
Today
:$
Malor Leagua 8or.ebol1
Note: The location of the banner can be moved
to the top or bottom of the screen by pressing.
or T while the RECALL or INFO display is on-
screen.
Understanding the auto power off
feature
The TV will automatically tum itself off after
approximately 15 minutes if it is tuned to a vacant
channel or a station that completes its broadcast for the
day. This feature functions in
ANT/CABLE
mode only.
Understanding the last mode
memory feature
If the power is cut off while you are viewing the
TV, the Last Mode Memory feature automatically
turns on the TV when the power is resupplied.
Note: If it's possible, and you will be away
from the TV for an extended period of time you
should unplug the power cord.