Table of Contents
Advertisement
Displaying TV status information
To display TV status information using RECALL:
Press
RE~LL
on the remote control.
The following information will display (if applicable):
• Current input (ANT, VIDEO 1, etc.)
• If ANT is the current input, either "CABLE" (for cable TV)
or "ANT" (for over-the-air broadcasts).
• Channel number (if in ANT mode)
• Channel label (if set)
• Digital signal strength indicator (bar graph in lower right
corner of box; for ATSC signal only)
• Stereo, Mono or SAP audio status (when HDMI input mode,
Dolby Digital or PCM)
• Video resolution
• Aspect ratio of incoming video signal (4:3 or 16:9)
• V-Chip rating status
-D).MUN·'
Understanding the auto power off
feature
The TV will automatically turn itself off after approximately
15 minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT mode and Built-In DVD mode (No disc) only.
Understanding the last mode
memory feature
If
the power is cut off while you are viewing the TV, the
Last Mode Memory feature automatically turns on the TV
when the power is resupplied.
Note: You should unplug the TV's power cord if it is possible
that you will be away from the TV for an extended period of time
after the power is restored.
To close the RECALL screen:
Press
RE~LL
again.
emm-MU.
MLB Young s
xxx.
East 9 OOpm -'1 OOpm
Todlll' " Molior Le'lqu..
B"'~"b.jll
To display TV status information using INFO:
Press
I~O
on the remote control.
The following additional information will display for off air
digital channels (if applicable):
• Title
• Duration
• Detailed description
I_h.,
Note: The location of the banner can be moved to the top or
bottom of the screen by pressing .. arT while the RECALL or
INFO display is on-screen. (The last position will be stored to
memory.)
I
56
Advertisement
Table of Contents
