Lan; Powering Monarch Hd - Matrox Monarch HD User Manual

10

LAN

The LAN port is an auto-sensing 10/100/1000 Base-T Ethernet port used to
connect Monarch HD to an Ethernet network via a standard RJ-45 Ethernet
cable. For information on how to connect to a network, see
Connection and

Powering Monarch HD

Power the Monarch HD device using an AC outlet via the external power supply
and a power cord. When power is supplied to Monarch HD, the device begins a
power-up sequence during which all LEDs illuminate. The device is ready when
two or more of the recording destination LEDs (USB port 1, USB port 2, SD
Card) turn off, depending on your settings. To power off Monarch HD,
disconnect Monarch HD from the power source. For power specifications, see
Appendix A, "Matrox Monarch HD
¦ Note When the device is powered off, all current settings are maintained and
any logged errors are cleared (see
²Caution When
Chapter 2, Matrox Monarch HD Hardware and Connections
Setup."
disconnecting the power
supply from Monarch HD,
make sure that you slide
back the casing on the
connector to release the
locking mechanism.
To AC
outlet
Specifications."
"Monarch HD errors"
Chapter 3, "Network
on page 44).
Monarch HD
External
power supply
Power cord