Mobile Set; Router's Port Forwarding - IQ CCTV IQR1920D4 User Manual

IQCCTV
The IQR DVR range is currently compatible with mobile phones running Android, Windows
Mobile and Symbian operating systems. As well as, iPhone and Black berry on 3G networks. To
configure, please follow the steps below;
1. Configure the network parameters. To do this, please refer to section 5.3.4.1.
2. Configure the mobile port no (such as 19011) and the port that you want to forward to.
Please refer to Section 5.3.4.3.
3. Save the parameters and exit the Main Menu
4. Restart the system
5. Enter the user name and password. The details of the mobile will the same as the DVR
Port forwarding is required when you want to access the DVR connected to the router from
outside of the router's network. If PPPoE is selected, port forwarding is not required.
1. Input the router's IP address from an Internet Explorer-based browser to open the
Router configuration interface.
2. Choose the [Transmittal rule] option to take you to the port forwarding instructions to
your router.
3. The DVR IP address for the intranet should be <192.168.1.101>. Forward Media port
(19009) and HTTP port (19010) to this IP address respectively.
4. Once this has been done, the DVR can be viewed remotely.
Please Note: The router's port forwarding interface may be different when entering into a virtual
server. The user will always need to forward port (range: 1025~65535) the router to the IP
address of DVR allocated or automatically captured. Select [All] or [Both] in corresponding
protocol column and save the above setting.
(The above steps may differ from the router device depending on the manufacturer.)
5.3.4.2

Mobile Set

5.3.4.3

Router's Port Forwarding

IQ1920DVR User Manual
32