Chapter 3 Dvr Connection; Hdd Installation; Camera And Monitor Connection - IQ CCTV IQR1920D4 User Manual

IQCCTV

Chapter 3 DVR Connection

3.1 HDD Installation

Caution Please do not Install or take out hard drive when DVR is running.
HDD Installation
(1) Cut power to the DVR
(2) Unscrew the screws and open DVR upper cover carefully
(3) Insert the Power Cord and data cable into Pin of hard drive securely
(4) Remove the screws on the HDD bracket.
(5) Fix the HDD to the bracket and then fix the bracket with HDD to DVR body
(6) Put the upper cover back carefully and re-attach the screws
Please Note: If the user requires a higher performance HDD, please contact the place of
purchase.

3.2 Camera and Monitor Connection

To connect camera a cable to the BNC video inputs at the rear of the DVR.
To connect the DVR to a monitor via the HDMI/VGA Video output connection.
If the camera is a PTZ speed dome, you can connect the RS485 A & B to the corresponding port
of the DVR (refer to system figuration on Chapter 8).
IQ1920DVR User Manual
12