Oneida Air Systems Dust Deputy AXD000009 Owner's Manual page 5

Assembly Instructions
11. Place included filter into handle space of top valve
inside of box. (Fig. 5) This prevents bag from being
sucked into valve and prevents dust from entering valve if
used without bag. (Light colored filter used for illustration
purposes.)
Fig. 5
12. Place bag into box, tucking into corners and folding top
Fig. 6
of bag over top of box. (Fig. 6)
Fig. 7
13. Place top on box and latch down, attach your hoses to the
Dust Deputy® inlet and outlet and you're ready to go! (Fig.7)
The UDD has the same footprint and fits onto the various
models of Festool vacuums the same way the Systainer tool
boxes do, because of that, on the Mini and Midi, the UDD will
protrude beyond their perimeters like the Systainer does.
If you want to run the Dust Deputy® without the bag, you must
Fig. 8
shut the valve by turning the valve handle 90 degrees. The system
must be air-tight to operate properly. Fig.8 shows valve in open
position.
Note: Before resuming using plastic bags you must vacuum
off the foam filter (Fig. 5) so air flow is not restricted.
7.
(Cont.)
Fig.6
Assembly Instructions for Ultimate Dust Deputy® Kit
Translucent Dust Deputy used for illustration purposes only.
1. Put the top of the
Front
latch through the
grounding loop as
shown. 2. Then thread
the loop from the back
through the top hole in
the latch. 3. Thread the
loop back through the
long hole in the latch
so the terminal ends up
behind the top screw
hole. 4. Attach handle
to box as shown.
Note: It is important that the grounding loops be threaded through
the latches in this way.
Gasket
Side
1
2
3
4
1. With a Phillips head screwdriver, attach
the two rubber latches with grounding loops,
one on either side of the dust collection box
using the (4) 10 x 32 x 1" machine
screws included in the hardware
pack. Make sure that the handle of
the latch curves downward when
attached or when in the up position
it points out.
2. Take the provided length of gasket, peel
the protective backing off of the gasket
and carefully place the gasket flat around
the underside of the box top as shown,
not on the side of the inside lid.
It is very important that there are no
gaps in the gasket where the ends meet.
Make sure they are butted together!
NO
YES
4.