Oneida Air Systems Dust Deputy AXD000009 Owner's Manual page 4

Ultimate Kit Contents
U.S. Patent #7,282,074 C1
U.S. Patent #D668409
AXD600000
SDS090000
RMF000060
VXC110009
AXD600200
AHK000009
AFL000007
AXD200060
RGZ000000
Dimensions
30.5" /
774.7 mm
3.
15.25"/ 387.35 mm
Plastic Ultimate Dust Deputy® - AXD000009
- Hose 2"x 60" - AXD200060
- Cyclone Plastic - VXC110009
- Molded 9 Gal. Box - SDS090000
ACB320000
- Rubber Latch (2) - AFL000007
- Gasket for Cyclone - AXG000004
- Gasket Neoprene (4') - RGZ000000
- Foam Block - RMF000060
AXG000004
- Clamp Band - ACB320000
- Tubing 1/4" (3') - AXD600200
- Plastic Bags (3) - AXD600300
- Grounding Loop (2) - WGX000000
AXD600300
- Anti-Static Metal Tape (12") - VFA050015*
- SD Elbow - AXD600104
- Hardware - AHK000009
AXD600104
- 1/4 - 20 x 3/4 Hex Head Bolt (6) - AFS015920
- 10-32 x 1" Mach. Screw (4)
WGX000000
*
- See pg. 8 for optional Anti-Static Tape use.
Tapered Inlet
Width:
11.25"/
287.75 mm
Assembly Instructions
If hoses are not tight on the inlet, or keep
pulling off, use the included clamp as
shown below.
Hose Clamp
Accessories
We recommend always using static conductive hoses and components. If a
non-conductive component is used, the ground pathway must be continued via
conductive tape or wire to bridge the gap between the conductive components.
By bridging this gap, the anti-static grounding pathway will be maintained.
Conductive Wire
Conductive Hose
Conductive Tape
Third Party
Non-Conductive Accessory
(Hoses,Fittings, Adapters,
Wands, etc...)
(Cont.)
Make sure larger
diameter hoses are
pushed up so they fit
tightly over the inlet
Conductive Hose
8.