Electrical Adjustments; Tuner Section; Http://Www.xiaoyu163.Com - Sony CDX-C8850 Service Manual

QQ
3 7 63 1515 0
CD SECTION
CD section adjustments are done automatically in this set.
0 dB = 1 µV

TUNER SECTION

Cautions during repair
When the tuner unit is defective, replace it by a new one
because its internal block is difficult to repair.
TEST MODE
This set have the test mode function. In the test mode, FM Auto
Scan/Stop Level and AM Auto Scan/Stop Level adjustments can be
performed easier than it in ordinary procedure.
<Set the Test Mode>
1. Set the "OFF" mode.
2. Push the preset 4 button.
3. Push the preset 5 button.
4. Press the preset 1 button for more than two seconds.
5. Then the display indicates all lights, the test mode is set.
<Release the Test Mode>
1. Push the OFF button.
Note on Adjustment
The adjustments of tuner section, should be performed according
to the following sequence.
1. FM Auto Scan/Stop Level Adjustment
2. FM Stereo Separation Adjustment (WIDE)
3. FM Stereo Separation Adjustment (NARROW)
TE
4. AM Auto Scan/Stop Level Adjustment
L 13942296513
www
.
20

http://www.xiaoyu163.com

SECTION 3

ELECTRICAL ADJUSTMENTS

x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
FM Auto Scan/Stop Level Adjustment
Setting :
SOURCE button : FM 97.9 (MHz)
FREQUENCY SELECT switch (CDX-C9500) : FM200K
FM RF signal
generator
Carrier frequency : 97.9 MHz
Output level : 22 dB (12.6 µV)
Mode : mono
Modulation : 1 kHz, 22.5 kHz deviation (30%)
Procedure :
1. Set to the test mode.
2. Push the SOURCE button and set to FM.
Display
3. Push the preset 3 button.
Display
Q Q
3 6 7 1 3 1 5
4. Adjust with the volume RV2 on TU101 so that the "FM"
indication turns to "FM0" indication on the display window.
But, in case of already indicated "FM0", turn the RV2 so that
put out light "0" indication and adjustment.
Display
Adjustment Location : See page 22.
co
.
9 4 2 8
antenna
terminal
0.01 µ F
set
SHUF
0 5 8 2 9 9 4 2 8
SHUF
SHUF
m
9 9
9 9