Accessories - Lincoln Electric IM610-A Operator's Manual

C-1
OPTIONAL ACCESSORIES
1. K520 Utility Cart — Designed to transport the
Lincoln family of small welders. Has provisions for
mounting a single gas cylinder. Has front casters
and large rear wheels. Handle height is easily
adjustable. Bottom tray provided for tools and
accessories. Easy assembly required; takes less
than 15 minutes.
2. K1800-1 CO Adjustable Regulator and Hose Kit —
2
Includes an adjustable pressure flow regulator for
use on CO cylinders.
2
Weld shielding gas may be obtained from a weld-
ing supply distributor.
Also included is a gas hose which connects to the
rear of the welder.
See "Gas Connection" in Installation section for
installation instructions.
3. K1799-1 Argon-Mixed Gas Adjustable
Regulator and Hose Kit
Includes an adjustable pressure and flow regulator
for use on argon-mixed gas cylinders. Also includ-
ed is a gas hose which connects to the rear of the
welder.
4. K586-1 Deluxe Adjustable Gas Regulator &
Hose Kit
Accommodates CO or mixed Gas Cylinders.
2
5. K663-2 Aluminum Welding Kit — This kit
required for welding with .035" aluminum wire.
Included with this kit are a drive roll and idle roll
assembly, liner and guide tubes and a contact tip.
It is important when changing between welding
with steel wire and aluminum to exchange
these components due to the lubricant applied
to steel wire. Failure to do so may result in con-
taminated welds when welding aluminum.
See Maintenance section for instructions on installing
drive roll, cable liner, contact tip and their proper con-
figuration.

ACCESSORIES

(1)
SP-175 PLUS
6. K695-2 Spot / Stitch Timer Kit — Includes spot
timer to control the spot welding arc time, and a
stitch timer to control the on/off cycle time of the
arc to prevent burnthrough on thin gauge metals.
Also includes spot welding nozzle.
The Spot/Stitch Timer Kit installs inside the wire
feed compartment, replacing the blank panel locat-
ed below the gun trigger lead connectors, per the
installation instructions included with the kit.
7. K549-1 .035 (0.9 mm) Innershield Welding Kit
Includes a contact tip, a gasless nozzle and a
cable liner to permit the Magnum™ 100L gun and
cable to use .035" (0.9 mm) diameter flux-cored
electrode. Also included is a spool of .035 (0.9
mm) Innershield NR-211-MP.
C-1