Identify And Locate Components - Lincoln Electric IM610-A Operator's Manual

A-2
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the SP-175 Plus Operating Manual
should install and operate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The SP-175 Plus power switch is to be in
the OFF ("O") position when installing
work cable and gun and when connecting
power cord to input power.
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the SP-175
Plus from its carton and remove all packing material
around the SP-175 Plus . Remove the following loose
items from the carton (see Figure A.1):
1. SP-175 Plus
2. Gun and cable assembly
3. Literature and miscellaneous including:
a) This operating manual
b) A contact tip for .030" (0.8 mm) diameter wire.
c) A contact tip for .035" (0.9 mm) diameter wire.
4. 10 ft (3.0 m) work cable.
5. Work clamp.
6. Sample Spool of L-56 .025 MIG Wire.
7. Adjustable mixed-Gas Regulator & Hose.
For available options and accessories refer to the
accessories section later in this manual.
1) As shipped from the factory, the SP-175 Plus gun
liner is ready to feed .023" (0.6 mm) -.035 (0.9 mm)
wire. The contact tip is sized for .025" (0.6 mm) wire
feeding.
INSTALLATION
(1)
1
3
5
SP-175 PLUS
FIGURE A.1
2
4
6
7
A-2