Set Up Guide; Setting Up The Base Station And Transmitter; Register Transmitter - Urban Green Energy UGE Operation Manual

SET UP GUIDE

Before placing and installing all components of the weather station at their final destination, please set
up the weather station with all parts being nearby for testing the correct function.

SETTING UP THE BASE STATION AND TRANSMITTER

Insert two pieces of LR6 (AA size) batteries into the transmitter, the LED located in the middle front
case of transmitter will be turned on for 4 seconds, after which the transmitter will be functioning.
When data is being transmitted the LED will flash for 20ms intervals.
After inserting the batteries into the Weather Station, all LCD segments will be turned on for a few
seconds.
The weather station will make initial measurements and start to register the transmitter. Do not
press any key before outdoor sensor data is received, otherwise the outdoor sensor learning mode
will be terminated. When outdoor transmitter has been registered, the base station will
automatically switch to the normal display mode from which all further settings can be performed by
the user.

REGISTER TRANSMITTER

If no outdoor weather data is displayed or the signal to the sensors is lost during setting up,
mounting, changing of batteries to the sensor or plugging or unplugging cables, simply press and hold
the DOWN/- key for 4 seconds and a short beep will sound to synchronize the base stations to
sensors. Weather data will not be received without synchronization.
Note:
Commonly the radio communication between receiver and transmitter in the open field can reach a
distance of up to 330 feet providing that there are no interfering obstacles such as buildings, trees,
vehicles, high voltage lines, etc.
Radio interferences such as PC screens, radios or TV sets can, in bad cases, entirely cut off radio
communication. Please take this into consideration when choosing standing or mounting locations.
6