Installation; Din Front/Rear-Mount; Din Front-Mount; Installation With The Rubber Bush - Pioneer Premier DEH-P520 Installation Manual

Installation

Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connect-
ed up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the dri-
ver's way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere hot
— for instance, near a heater outlet.

DIN Front/Rear-mount

This unit can be properly installed either from "Front" (conventional DIN Front-mount) or
"Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit
chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Installation with the rubber bush (Fig. 12)
Dashboard
15
1
182
53
• If installation angle exceeds 60° from horizontal,
the unit might not give its optimum performance.
(Fig. 11)
Holder
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
2
board material and bend them.
(Install as firmly as possible using the top
and bottom tabs. To secure, bend the tabs
90 degrees.)
Rubber bush
3
Screw 4
60°
Fig. 11
Fig. 12