Advertisement
Available languages
Available languages
Installation
Note:
DIN Front-mount
•
Before finally installing the unit, connect the
wiring temporarily, making sure it is all connect-
ed up properly, and the unit and the system work
7 Installation with the rubber bush
properly.
•
Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
2
can cause malfunctions.
1
•
Consult with your nearest dealer if installation
182
requires the drilling of holes or other modifica-
tions of the vehicle.
•
Install the unit where it does not get in the dri-
53
3
ver's way and cannot injure the passenger if there
4
is a sudden stop, like an emergency stop.
•
If installation angle exceeds 30° from horizontal,
the unit might not give its optimum performance.
30°
1. Dashboard
2. Holder
After inserting the holder into the dashboard, then
select the appropriate tabs according to the thick-
DIN Front/Rear-mount
ness of the dashboard material and bend them.
(Install as firmly as possible using the top and the
This unit can be properly installed either from
bottom tabs. To secure, bend the tabs 90
degrees.)
"Front" (conventional DIN Front-mount) or
"Rear" (DIN Rear-mount installation, utilizing
3. Rubber bush
threaded screw holes at the sides of unit chassis).
4. Screw
For details, refer to the following illustrated
installation methods.
7 Removing the Unit
7
5
6
5. Frame
7. Insert the supplied extraction keys into the unit,
6. Insert the release pin into the hole in the bottom
as shown in the figure, until they click into place.
of the frame and pull out to remove the frame.
Keeping the keys pressed against the sides of the
(When reattaching the frame, point the side with
unit, pull the unit out.
a groove downwards and attach it.)
DIN Rear-mount
7 Installation using the screw holes on
the side of the unit
1. Remove the frame.
2. Fastening the unit to the factory radio mount-
ing bracket.
8
10
9
10. Select a position where the screw holes of the
bracket and the screw holes of the head unit
become aligned (are fitted), and tighten the
8. Frame
screws at 2 places on each side. Use either truss
screws (5 × 8 mm) or flush surface screws
9. Insert the release pin into the hole in the bottom
(5 × 9 mm), depending on the shape of the screw
of the frame and pull out to remove the frame.
holes in the bracket.
(When reattaching the frame, point the side with
a groove downwards and attach it.)
<ENGLISH>
11
13
12
11. Screw
12. Factory radio mounting bracket
13. Dashboard or Console
Advertisement
