Lincoln Electric BULLDOG SVM208-A Service Manual page 80

F-32
BRUSH REMOVAL AND REPLACEMENT (continued)
CABLE
BRUSHES
PROCEDURE
1. Remove the spark plug wire.
2. Open the brush holder assembly cover.
Squeeze the 2 tabs and depress the cover at
the top with a screw driver or your fingernail.
The cover will drop open on its bottom hinge.
3. With the 1/4" nut driver, remove the 2 screws
that hold the brush holder assembly in place.
4. With the needlenose pliers, gently remove the
black and the red wires.
NOTE: The red wire is inboard. "RED" is marked
on the brush holder beside the terminal for
the red wire.
TROUBLESHOOTING AND REPAIR
FIGURE F.10 – BRUSHES RETAINED WITH CABLE TIE
TIE
BULLDOG® 140
5. To change the brushes, use the slot head screw
driver to pop off the plastic retainer on the back
of the brush holder assembly.
6. Remove the old brush assemblies and insert
the new ones. One corner of the terminal clip
is beveled so that the brush can go in only one
way.
7. Snap the plastic retainer back onto the brush
holder. The brushes may need some reposi-
tioning; wiggle them slightly to help them seat
properly on the slip rings.
F-32