Error Information - Sanyo PLC-XU88-WXU30 Owner's Manual

Error information

Error messages
Set up the parameter.
It has not been registered to PJ as
a group.
Cannot be displayed as PJ is under
display.
Cannot connect to PJ.
Cannot transfer data to PJ.
Cannot receive data from PJ.
Other PC has authority. Cannot
complete "Network Communica-
tion".
Other PC has authority. Cannot
obtain authority.
Invalid port number
PJ has not started Network Com-
munication. Close the window and
open it again.
Cause and corresponding
Error when the communication is executed. The parameter setting (host
name, capture port) has not been set.
Check parameter setting ( p.88)
Error when Start Communication or Start real time capture is executed. The
IP address of the computer has not been registered.
Register the IP address by using the web browser ( p.95)
Error when Start Communication or Start real time capture is executed. The
other capture, viewer or advanced card imager function is now operating.
Wait until the communication function is available.
Cannot establish the connection with the projector when the Start com-
munication is executed, Terminate Communication, Capture transfer, Start
real time capture or End real time capture.
Check connection of the network cable.
Cannot transfer the data to the projector when the Start Communication,
Terminate Communication, Capture transfer, Start real time capture or End
real time capture is executed. The time-out period is 10 seconds.
Check the connection of the network cable.
Cannot receive the data from the projector when the Start Communica-
tion, Terminate Communication, Capture transfer, Start real time capture or
End real time capture is executed. The time-out period is 10 seconds.
Check the connection of the network cable.
When executing the Terminate Communication, you cannot quit the com-
munication because other computer has an authority
Other computer has an authority.
When the parameter is set, the reserved port number is specified.
Check the parameter setting ( p.88)
The projector might have turned off during the communication.
Check the projector power and re-execute "Start communication".
Frror information
107