Set The Vmd Areas [Vmd Area] - Panasonic WV-SW158 Operating Instructions Manual

[Area]
When selecting a VMD area in the screen, it will be numbered as area 1. (Subsequent areas will be numbered
in the order of selection.)
[Status]
Select "On" or "Off" to determine whether or not to perform video motion detection.
•
On: Performs video motion detection.
•
Off: Does not perform video motion detection.
•
Default: Off
[Detection area]
Adjust the size of the detection area in the VMD area using the slider. The smaller the selected value is, the
higher the sensitivity of VMD area becomes. The current value (1-10) will be displayed on the right of the slider.
•
Default: 1
[Detection sensitivity]
Adjust the sensitivity of motion detection in the VMD area using the slider. The settings can be configured for
each area individually. The larger the value is set, the higher the sensitivity level becomes.
The current value (1 (low) - 15 (high)) will be displayed below the slider.
•
Default: 8
[Delete] button
Click the [Delete] button corresponding to the area to be deleted. The outline of the selected area will be
deleted.
[Light detection control]
Select "On" or "Off" to determine whether or not to suspend video motion detection affected by brightness
change such by a dimming level control.
•
Default: Off
IMPORTANT
•
"Light detection control" may not work when brightness change is too small.
•
When "On" is selected for "Light detection control", the video motion detection may not be performed
even when detecting a subject moving over the whole screen.
[Area No. notification]
When "Panasonic alarm protocol notification >>" is clicked, the [Notification] tab of the "Alarm" page will be
displayed. (®page 117)
VMD information addition
[Information addition]
Select "On" or "Off" to determine whether or not to add VMD information to superimposed image data.
The VMD information can be searched by some of Panasonic network disk recorders. Refer to the operating
instructions of the connected devices for further information about the functions and settings.
•
Default: Off

13.4.1 Set the VMD areas [VMD area]

Set the areas to activate the VMD function.
13 Configure the alarm settings [Alarm]
Operating Instructions 111