Panasonic WV-SW158 Operating Instructions Manual page 50

10 Configure the basic settings of the camera [Basic]
Note
•
Due to auto port forwarding, the port number may sometimes be changed. When the number is
changed, it is necessary to change the port numbers registered in the PC and recorders, etc.
•
The UPnP function is available when the unit is connected to the IPv4 network. IPv6 is not supported.
•
To check if auto port forwarding is properly configured, click the [Status] tab on the "Maintenance" page,
and check that the "Enable" is displayed for "Status" of "UPnP". (®page 174)
When "Enable" is not displayed, refer to "Cannot access the unit via the Internet." in
23 Troubleshooting.
•
When the "UPnP (Auto port forwarding)" setting is changed, the "Auto port forwarding" setting under
"UPnP" on the [Network] tab of the "Network" page also changes to the same setting.
[Area]
Select the region where the camera is installed. If the camera is used outside of Japan, select "Global". If the
camera is used in Japan, select "Japan".
Japan/Global
[Service]
Select "Viewnetcam.com" or "Off" to determine whether or not to use "Viewnetcam.com".
By selecting "Viewnetcam.com" and clicking the [Set] button, the registration window for "Viewnetcam.com"
will be displayed in a newly opened window.
Follow the on-screen instructions to register with "Viewnetcam.com".
Refer to page 161 or the "Viewnetcam.com" website (http://www.viewnetcam.com/) for further information.
•
Default: Off
Note
•
When the "DDNS" setting is changed, the "DDNS" setting on the [DDNS] tab of the "Network" page
also changes to the same setting.
[Recommended network setting for internet]
The recommended settings for connecting to the Internet are performed here.
By clicking the [Set] button, a dialog displaying how the following settings will change is displayed.
Click the [OK] button after checking the settings to change the settings to the displayed values.
–
[JPEG/H.264] tab on the "Image/Audio" page
JPEG
[Image capture size]: VGA/640x360
[H.264(1)]/[H.264(2)]
[Internet mode (over HTTP)]: On
[Transmission priority]: Best effort
[Max bit rate (per client)*]: Max. 1024 kbps, Min. 128 kbps
[H.264(1)]
[Image capture size]: VGA/640x360
[H.264(2)]
[Image capture size]: QVGA/320x180
–
[Network] tab on the "Network" page
[Common]
[Max RTP packet size]: Limited(1280byte)
[HTTP max segment size(MSS)]: Limited(1280byte)
Note
•
When "H.264(1)" is selected for "Recording format" of the SD memory card, the "Transmission
priority" setting for "H.264(1)" will not change. If "H.264(2)" is selected for "Recording format", the
"Transmission priority" setting for "H.264(2)" will not change.
•
When "3 mega pixel [4:3]" is selected for "Image capture mode", the "Image capture size" setting will
not change, but "Max bit rate (per client)*" will change to Max. 1024 kbps and Min. 256 kbps.
50 Operating Instructions